Circle Scan with Vision

Software topics related to Nikon iNexiv and Retrofit Camera
Post Reply
shamwasu
User
User
Posts: 10
Joined: Wed Sep 05, 2018 7:54 am

Circle Scan with Vision

Post by shamwasu » Fri Sep 07, 2018 2:05 am

Just a Query..

Is it possible to Scan Circle with Vision in CMM Manager 3.8

Input will be in Circle Co-ords, Scan Angle, Pitch or Number of points.

Machine VMZ-R

Thanks in Advance.

medupriest
SUDO
SUDO
Posts: 423
Joined: Fri Mar 13, 2015 11:59 am

Re: Circle Scan with Vision

Post by medupriest » Sat Sep 15, 2018 10:08 am

In the next release of the software, you will be able to input a target point density rather than a target number of points. What you may be looking for is just the edge profile from the Vision ribbon tab. This will allow you to enter a point density and a start and direction point. A closed scan will just measure a feature until the scan reaches its start point.

User avatar
CrashN8
Site Admin
Site Admin
Posts: 588
Joined: Thu Feb 09, 2017 4:07 pm

Re: Circle Scan with Vision

Post by CrashN8 » Wed Oct 24, 2018 11:56 am

Also version beyond 3.8 will allow for DCC Re-Measure. This means you can measure three points using simple tool on hole, then setup circle measurement using similar tools to DCC TP programming - number of points, spacing, etc. can all be adjusted.

shamwasu
User
User
Posts: 10
Joined: Wed Sep 05, 2018 7:54 am

Re: Circle Scan with Vision

Post by shamwasu » Thu Oct 25, 2018 6:59 am

Thanks..!!

Post Reply