Page 1 of 1

Circle Scan with Vision

Posted: Fri Sep 07, 2018 2:05 am
by shamwasu
Just a Query..

Is it possible to Scan Circle with Vision in CMM Manager 3.8

Input will be in Circle Co-ords, Scan Angle, Pitch or Number of points.

Machine VMZ-R

Thanks in Advance.

Re: Circle Scan with Vision

Posted: Sat Sep 15, 2018 10:08 am
by medupriest
In the next release of the software, you will be able to input a target point density rather than a target number of points. What you may be looking for is just the edge profile from the Vision ribbon tab. This will allow you to enter a point density and a start and direction point. A closed scan will just measure a feature until the scan reaches its start point.

Re: Circle Scan with Vision

Posted: Wed Oct 24, 2018 11:56 am
by CrashN8
Also version beyond 3.8 will allow for DCC Re-Measure. This means you can measure three points using simple tool on hole, then setup circle measurement using similar tools to DCC TP programming - number of points, spacing, etc. can all be adjusted.

Re: Circle Scan with Vision

Posted: Thu Oct 25, 2018 6:59 am
by shamwasu
Thanks..!!